Oregon has restricted three bridges on Route 20 to legal axle weights and an overall gross weight limit of 105,500 pounds.
This restricts these bridges to single axle weights of 20,000 pounds and tandem axle weights of 34,000 pounds. The affected bridges are the North Fork Malheur River Bridge at mile marker 190.84, Gwynn Crossing Bridge over the Malheur River at mile marker 195.12, and Sperry Bridge over the Malheur River at mile marker 205.58.
The detour uses Route 26 and U.S. 395. It is marked with signs and allows annual heavy haul permit holders to operate without buying an additional permit, even though the detour route is not an annual permit route. Loads over 9 feet wide require a front pilot, and loads over 12 feet wide require both front and rear pilots.
Oregon Announces Bridge Weight Restrictions
Oregon has restricted three bridges on Route 20 to legal axle weights and an overall gross weight limit of 105,500 pounds
More Drivers
Best Fleets to Drive For: Two Carriers Earn Overall Award for First Time
CarriersEdge announced the 2026 Best Fleets to Drive For overall winners, with Crawford Trucking, Fortigo Freight Services, and FTC Transportation receiving top awards.
Read More →
Federal Proposal Would Allow Pell Grants for Shorter-Term Job Training
The Department of Labor plans to expand Pell Grant eligibility to some shorter workforce training programs, a move the American Trucking Associations said will help strengthen commercial driver training schools and diesel technician training programs.
Read More →
How Thermo King’s AI-Fueled Telematics Drive Fleet Efficiency
Thermo King's AI-powered telematics enhance fleet efficiency with smart monitoring, predictive maintenance, and real-time insights. Improve uptime and help reduce costs with these advanced digital solutions.
Read More →
Owner-Operator Model Gets Boost as DOL Proposes 2024 Independent Contractor Definition Reversal
For an industry that has watched this issue go back and forth for years, the independent contractor proposal marks the latest swing in the regulatory pendulum.
Read More →
FMCSA Reinstates Field Warrior ELD to Registered Device List
One electronic logging device has been reinstated to the FMCSA's list of registered ELDs.
Read More →
How One Company is Using Smart Suspension Technology to Reduce Driver Injuries and Improve Retention
America’s Service Line adopted Link’s SmartValve and ROI Cabmate systems to address whole-body vibration, repetitive strain, and driver turnover. The trucking fleet is already seeing measurable results.
Read More →
CarriersEdge Announces 2026 Best Fleets to Drive For
The 18th annual contest recognizing the best workplaces for truck drivers sees changes to Top 20, Hall of Fame
Read More →
FMCSA Targets 550+ ‘Sham’ CDL Schools in Nationwide Sting Operation
The Federal Motor Carrier Safety Administration issued more than 550 notices of proposed removal to commercial driver training providers following a five-day nationwide enforcement sweep. Investigators cited unqualified instructors, improper training vehicles, and failure to meet federal and state requirements.
Read More →
DOT Alleges Illinois Issued Illegal Non-Domiciled CDLs
Illinois is the latest state targeted and threatened with the loss of highway funding by the U.S. Department of Transportation in its review of states' non-domiciled CDL issuance procedures. The state is pushing back.
Read More →FMCSA Locks in Non-Domiciled CDL Restrictions
After a legal pause last fall, FMCSA has finalized its rule limiting non-domiciled commercial driver's licenses. The agency says the change closes a safety gap, and its revised economic analysis suggests workforce effects will be more gradual than first thought.
Read More →