Vehicle maintenance violations are a huge threat to a carrier's safety record. There are close to 200 separate violations on FMCSA's list of point-carrying infractions, and many carry ratings of 5 points or higher.
Obviously, some are more common than others, but for a roadside inspector, finding violations on a commercial vehicle is like shooting fish in a barrel. It depends on how diligent they are and how badly they want to write up a driver, said Annette Sandberg, former FMCSA administrator and now CEO of a safety consulting firm called TransSafe.
"Any inspector can pull over any truck and find a violation," she said. "It's big equipment that's used in a strenuous environment; things can jiggle loose, they break. If inspectors want to be picky, they will find a violation."
The Vehicle Maintenance BASIC is also one of the hardest areas for carriers to improve because of the frequency of the violations and relative ease at finding them. It's one where carriers can use all the help they can get.
Here's a list of the five most common vehicle maintenance violations discovered in roadside inspections:
Inoperative required lamps. Non-working headlamps, tail lamps and turn signals.
No or defective lighting. Missing or defective lighting such as retro-reflective striping or projecting lighting such as rotating beacons on oversize loads.
Inspection/repair and maintenance, parts and accessories. Defects discovered by an inspector but not noted on the driver vehicle inspection report (DVIR).
Tire tread depth less than 2/32 inch. Fleets normally take three tread depth measurements around a tire and average them out for tire wear analysis, but DOT inspectors can cite a tire with any single spot worn to less than 2/32, which could include flat-spotted areas.
Oil and/or grease leak. This one is self-explanatory and illustrative of the challenge that fleets have in keeping the Vehicle Maintenance BASIC clean.
There are also several brake violations on the Top 10 list. They are serious, and almost all brake violations are worth 10 points.
From the April/May 2012 issue of HDAJ
Top 5 Vehicle Maintenance Violations
Vehicle maintenance violations are a huge threat to a carrier's safety record. There are close to 200 separate violations on FMCSA's list of point-carrying infractions, and many carry ratings of 5 points or higher
More Maintenance

Fontaine Expands Flatbed Lineup with New Fleet-Focused Models, Eyes 2027 Launch
Fontaine is broadening its flatbed lineup with new models aimed at fleets, including a lightweight aluminum trailer expected in 2027 that emphasizes durability, repairability, and lower cost.
Read More →
Fullbay Acquires Pitstop to Strengthen AI-Powered Predictive Maintenance
Pitstop AI will use Fullbay's extensive shop data to drive predictive maintenance for trucking fleets and repair shops.
Read More →
HDT Honors the Best New Products of 2025 at TMC [Photos]
Heavy Duty Trucking's Top 20 Products awards recognize the best new products and technologies. Check out the award presentations at the 2026 Technology & Maintenance Council annual meeting.
Read More →
Detroit Engines: Trusted Performance, Built for What's Next
The Detroit® Gen 6 engine platform proves that real progress doesn’t require a complete redesign. Built on 20 years of trusted technology, these engines are designed for efficiency, stronger performance, and greater reliability than before. And they do it all while complying with 2027 EPA standards on every mile.
Read More →
EPA Targets DEF Sensor Failures Behind Truck Derates
New guidance allows engine makers to replace problematic DEF sensors with NOx-based systems, aiming to reduce unnecessary derates and downtime caused by failures in the sensors designed to monitor diesel exhaust fluid on trucks.
Read More →
Goodyear Targets ‘Super-Regional’ Sweet Spot with New Steer Tire
Goodyear is preparing to roll out a new steer tire designed to bridge the gap between regional and linehaul for trucking fleets.
Read More →
Hendrickson Unveils Watchman Smart Wheel-End System at TMC
Hendrickson’s new sensor platform integrates with its TireMaax system to deliver real-time tire and wheel-end insights, targeting uptime and cost savings.
Read More →
Over-the-Air Updates and the Modern Powertrain Explained
Over-the-air updates are moving beyond recalls, and expanding how fleets manage performance, compliance, and uptime.
Read More →
SKF, TMC Expand Hands-On Training to Boost Technician Skills at Annual Meeting
A new partnership between SFK and TMC brings certified, on-site instruction focused on wheel-end reliability and maintenance best practices.
Read More →
Why Higher Pay Isn’t Fixing the Heavy-Duty Technician Shortage
Hiring heavy-duty truck technicians has become a bidding war, but shops that focus on culture, training, and career paths are gaining an edge. That's the takeaway from a TMC panel discussion.
Read More →
