FHWA Clarifies What a Nondivisible Load Is
The Federal Highway Administration has provided a clarification on the federal definition of a nondivisible load in a response to the Specialized Carriers & Rigging Association.

The Federal Highway Administration gave clarification on the definition of an indivisible load, focused on the dubious use of the word "or".
Photo: Evan Lockridge
The Federal Highway Administration has provided a clarification on the federal definition of a nondivisible load in a response to the Specialized Carriers & Rigging Association.
The SC&RA had sent an inquiry to the FHWA asking for clarification on the definition of a nondivisible load as it pertains to all loads, and to the transportation of transformers containing fluid. In the official definition, the word “or” in part of the explanation caused some uncertainty.
The federal definition of nondivisible is given in 23 CFR 658.5 as:
Nondivisible means any load or vehicle exceeding applicable length or weight limits which, if separated into smaller loads or vehicles, would:
(i) compromise the intended use of the vehicle, i.e., make it unable to perform the function for which it was intended:
(ii) destroy the value of the load or vehicle, i.e., make it unusable for its intended purpose; or
(iii) require more than 8 work hours to dismantle using appropriate equipment.
In response the FHWA gave the following clarifying answer:
“As you (SC&RA) assert, the word 'or' at the end of (ii) means that a load that meets any one or more of the three definitions shall be considered nondivisible. States are required to use the federal definition only when considering whether to issue a nondivisible load permit allowing an overweight vehicle or load to operation on the Interstate System and roads providing reasonable access to and from the Interstate.”
According to an SC&RA notice, the “or” in part (ii) of the definition had resulted in states deferring exclusively to part (iii) of the definition, “where the removal of counterweights, etc., typically takes far less than 8 work hours to dismantle. However, the FHWA’s response clarifies that, “loads may still be defined as nondivisible if the removal of the objects will make the load unable to perform the function and will make it (the load) unable to perform the function and/or unusable for which it was intended.”
Related: New Personal Conveyance Guidance Gives Flexibility to Find Truck Parking
More Safety & Compliance

ATRI Wants Motor Carriers for Driver-Facing Camera Study
In this new study, the American Transportation Research Institute will explore how driver-facing cameras can impact safety and operational metrics in trucking fleets.
Read More →
Netradyne Intelligence Uses New AI Agents to Automate Response to In-Cab Camera Data
The company called the next-generation in-cab camera safety platform "a fundamental shift from systems that report on what happened to systems that actively drive what should happen next."
Read More →
Mack, Volvo Issue ‘Do Not Drive’ Recall on Possible Wheel-Offs
Owners will be sent advance notice not to operate their affected vehicles until the remedy is performed.
Read More →
Fleetworthy Integrates Lytx Video Snapshots into Safety+ Platform
A new Fleetworthy-Lytx integration gives fleet managers access to video context alongside safety event data, streamlining driver coaching and incident review.
Read More →How Waste Connections is Using Data, Telematics, and AI
How do you manage and maintain more than 18,000 connected trucks? Data. Lots of it.
Read More →
Fleet Advantage: Top Logistics Fleets Outperform National Safety Benchmarks
Fleet Advantage's latest TRUST Safety Index found leading logistics fleets maintained significantly lower out-of-service rates and stronger safety scores than national averages, while highlighting persistent challenges related to tires, brakes, and unsafe driving behaviors.
Read More →
Why Fleet Data Matters More Than Ever at Waste Connections [Watch]
Waste Connections' Chuck Palmer explains how telematics, predictive maintenance, safety analytics, and AI help keep vehicles on the road and drivers safe in this episode of HDT Talks Trucking.
Read More →
Short Takes: How K&B is Using AI
Fleets need to "get on board the train" with AI, says Lance Evans of K&B Transportation in this HDT Talks Trucking Short Takes episode.
Read More →Short Takes: Inside K&B’s Truck Safety Tech
Listen to learn how K&B Transportation uses cellphone-blocking technology, speed management systems, weather geofencing, bridge avoidance tools, and more to improve driver safety.
Read More →
The Biggest Gap in Driverless Trucking Isn’t Tech. It’s Safety Validation
Nauto’s Stefan Heck says autonomous trucks are advancing quickly but proving they’re safe enough for large-scale deployment may be the industry’s hardest challenge.
Read More →
