Deflecting Fuel Savings
A driver's suggestion saved this small fleet $1 million on fuel in just two years..


When the transistor was invented in Bell Labs in 1947, its creators could have had no inkling of the uses it would create. Similarly, a small group in Ada, Mich., is casting around for applications for new technology: smart electrical power over an air gap.
Power-over-an-air-gap is the ability to transmit electrical power without a physical hard-wired connection.
Yes, you say, I know about that. My electric toothbrush charges in its cradle; those European kettles boil water when placed over their bases.
And to an extent, that's right. Except these applications are not "smart."
A new company, Fulton Innovation, has developed a technology that uses similar inductive coupling to get power from a primary winding to a second, but it is accompanied by electronics that recognize what that secondary is: its voltage, the power required, even the way the power is conditioned to best be used by the secondary.
A great illustration of the application of this technology was shown at the National Truck Equipment Association's Work Truck Show, where it garnered the award for the most innovative new product. Installed on a Legget & Platt converted utility van, the shelving and accessories of the van were configured so that 36-volt power tools automatically recharged simply by placing them on a work surface.
The vehicle in the show had a counter with a decal indicating where to rest the Bosch tool. The battery was then in close proximity to the coil embedded in the table. This and the associated electronics queried the battery in the tool, discovering it was a 36-volt rechargeable. A light at the edge of the table illuminates to indicate the battery is charging. Moreover, the battery has been queried to see if it is relatively new, or has been deep cycled thousands of times. It then gets the optimum charge cycle.
When work at the site is complete, the tools - say a drill and a reciprocating saw for instance - are put back into the compartments in their carry case, and it is put into its bin on the vehicle's racking. The case has an enabled liner that talks to the tools, the liner talks to the van through the shelf and the tools recharge on the way back to the depot. There are no power bricks, no inverters. The whole thing just runs off the van's 12-volt system.
Outside, the van has a flip-down work surface with a recharge spot. Working with the tools, the operator simply needs to rest them back on the spot for batteries to be kept up to charge.
Want a sign that says "Danger?" Just hang it over the power point installed at the rear of the vehicle and it gets its power wirelessly.
You can do the same in the vehicle's center console. Throw your cellphone, Blackberry and iPod into one of the available mini-bins and the system recognizes them for a recharge. Three-volt battery powered flashlight? Just chuck it in. The system will find its resonance and hook it up to charge. You could have an embedded primary in the windshield where you attach the navigation system. Clamp it to the glass and it is automatically powered.
Pretty cool. Now think about that flip-down table in the sleeper of a long and tall. A power spot there means a driver can pull out the 110-volt coffee pot, set it down appropriately filled with water and ground coffee, and in moments there's fresh brewed coffee. Or place the laptop there. The system sees a 15-volt battery and hooks it up. Imagine a truck cab free of recharger bricks for each portable electronic aid. And also imagine drivers not plugging too big an inverter into a cigar lighter outlet and frying the electrical system or burning down the truck. Definitely a good thing.
And how about electrical connections that are subject to corrosion, such as the J560 cord between tractor and trailer? All those connections can be made through non-contact power connections using this technology.
Maybe you don't need IdleAire or plug-in shore power. All you need is a pigtail that suction-mounts to the appropriate panel on the outside of the truck. You could just pull up to a wheel chock to locate the truck and you're hooked to an in-ground power primary. You still need some electrical infrastructure at the truckstop or terminal, but you have no conductor-connection with its associated dangers in wet weather. Conceivably, you could hook up an electrical standby to a reefer in exactly the same way, since according to the Fulton scientists, the power-over-air-gap is entirely scalable.
It's a fascinating technology with applications that are likely limited only by our imaginations.
More Fleet Management

Trucking's Annual Congestion Costs Reach $128.2 Billion
That's the average cost, according to new ATRI research. And the wasted time and diesel are staggering.
Read More →
How to Modernize Your TMS Without Replacing It [Podcast]
Before investing in a new transportation management system, take a closer look at what you've already got. AI, cloud technology and better integrations may offer ways to improve your trucking operations without starting over.
Read More →
Could Your Truck's Connected Devices Be a Cybersecurity Risk?
ELDs, telematics systems and driver tablets help fleets operate more efficiently. But every connected device needs protection against cyberattacks.
Read More →
Holiday Freight Meets a Tight Trucking Market
There's no freight boom, but truckload carriers are finding themselves in a stronger position to negotiate rates. And holiday shipping demand could tighten the market further.
Read More →
What Trucking Events are Happening in 2027?
Looking for trucking-related conventions, expos, and other events? Heavy Duty Trucking has developed this list of national and larger regional trucking shows and events.
Read More →
Does Your Trucking Fleet Need a New TMS?
Artificial intelligence and better integrations promise less busywork and more useful data. Can your TMS help your company solve problems? Do you need additional vendors or an upgrade? Or is it time to look for a new platform?
Read More →
Fleet Costs Shape ACT Expo 2027 Agenda
With diesel prices high and operating expenses under pressure, ACT Expo's 2027 agenda emphasizes fuel efficiency, AI, safety and the return on fleet technology investments.
Read More →
Does Your Trucking Fleet Need a New TMS? [Video]
Cloud technology, AI and new integrations are changing what transportation management systems can do. But does taking advantage of those advances mean replacing your existing TMS?
Read More →
Road Ready Becomes Saegic, Launches New Trailer Telematics Gateway
Clarience Technologies is rolling out new hardware and expanding its plans for connecting trailer telematics, maintenance data, and video.
Read More →
Give Your Trucking Fleet a Cybersecurity Walkaround
Your fleet's cybersecurity policies may look good on paper. These seven checks can help you find out whether they’re working.
Read More →
