Trailer Orders Fall in January
Preliminary reports indicate trailer orders in January fell about 34 percent compared to December 2020 orders, according to ACT Research and FTR.

Preliminary reports indicate trailer orders in January fell about 34 percent to about 30,000 units compared with December 2020 orders, according FTR.
Graph: FTR
Preliminary reports indicate trailer orders in January fell about 34 percent to about 30,000 units compared to December 2020 orders, according to ACT Research and FTR.
However, January orders were between 83% to 94% higher than the same month last year.
January trailer order activity met expectations, as most of the large fleets had already placed their 2021 requirements orders previously, FTR officials said in a press release.
A couple of OEMs, for example, are booked solid for dry vans for all of 2021 and have limited capacity to book additional orders. Orders for refrigerated vans have been robust for the last four months, and orders for flatbeds have risen noticeably over the last two months and are expected to continue to improve in January.
“The year-over-year gain, with OEMs booking almost twice the volume they reported last January, was in line with expectations, as the industry continues to see solid interest from fleets for equipment acquisition,” said Frank Maly, director of commercial vehicle transportation analysis and Research at ACT Research.
The slower order pace versus December was also anticipated, Maley added.
“The order surge last September through December, which sets the stage for solid production volumes this year, is actually somewhat of a limiting factor for additional orders in the short-term. For dry vans and reefers, orderboards currently commit many OEMs into late 2021, and that means 2021 production slots are becoming a rare commodity,” Maley said.
Increasing production rates continue to be a challenge for trailer OEMs, as headwinds from increasing staff and growing concerns regarding materials and components supplies are evident, Maley said.
“The good news about January orders is that flatbed orders continue to recover,” said Don Ake, FTR’s vice president of commercial vehicles. “This will allow OEMs to raise build rates through the first half of the year. Dump and tanker orders are also expected to show gains. This means the manufacturing and the industrial sectors are showing strength, and this should translate to lower unemployment and GDP support later in the year.”
Trailer orders for the past twelve months total 313,000.
More Equipment

Atlas Expands Kodiak Driverless Truck Fleet in Permian Basin
Atlas Energy Solutions is expanding autonomous frac sand hauling in the Permian Basin with a second load-out location and plans for 100 driverless trucks by mid-2027.
Read More →
Putting Mack’s Command Steer to the Test
A test drive of Mack’s Command Steer active steering system evaluates how it can make truck driving easier and less tiring.
Read More →
Mack, Volvo Expand DEF Derate Software Updates
The updated software gives Mack and Volvo truck owners more time to address DEF-related issues before the engine derates or the vehicle goes into reduced-speed inducement, following new EPA guidance.
Read More →
Rush, MCT Team Up to Grow Refrigeration Service Network
The joint venture will operate MCT's network of Carrier Transicold dealerships and mobile service locations, with the companies promising greater service capacity and uptime for refrigerated fleets.
Read More →
Cummins Adjusts 2027 Engine Rollout After EPA Proposal
The engine maker will gradually introduce its new Model Year 2027 diesel engines while continuing to offer current models during the transition, citing the EPA's proposed emissions rule changes.
Read More →
Aurora Rolls Out Next Generation of Driverless Trucks for Commercial Freight
Aurora's latest autonomous trucks it's rolling out with International feature lower-cost hardware designed for a million miles as the company expands commercial driverless freight operations across the U.S. Sun Belt.
Read More →
Peterbilt 589 Spotlight: A Close Look at a Custom Working Truck [Video]
There's more to this customized Peterbilt Model 589 and Great Dane refrigerated trailer than chrome and stainless (although there's plenty of that too!) A veteran driver explains the design choices and practical features behind this working truck.
Read More →
Continental Expands Retread Lineup With New ContiTread HDL 5 EP
New long-haul drive retread is designed to improve fuel efficiency, extend tread life, and lower fleets' cost per mile.
Read More →
EPA Proposal Could Ease 2027 Truck Costs and Buying Uncertainty
The proposal doesn't change the tougher NOx standard, but it would revise key implementation requirements that manufacturers say have driven up costs and complicated fleet purchasing decisions.
Read More →
Cummins, Paccar Ease DEF Derates After EPA Guidance
Updated diesel engine software gives truck operators more time to address emissions-system issues while staying compliant with EPA emissions standards.
Read More →
