Commentary: Trucks Could Borrow From F1 Hybrid Tech

The latest hybrid V-6 Formula One engines are marvels of technology that may give us a glimpse into the future of truck efficiency and performance.

January 2015, - Editorial

by Rolf Lockwood

SHARING TOOLS        | Print Subscribe
Rolf Lockwood, Executive Contributing Editor. 
Rolf Lockwood, Executive Contributing Editor.

The pinnacle of automotive engineering, and easily its most expensive pursuit, is to be seen in the sometimes nutty world of Formula One racing. The 2014 season just finished and it was no exception to that nutty rule. Mercedes-Benz took the title, its drivers finishing one-two while winning 15 of the year’s 18 races. Total dominance like never before, almost solely because its engines were dramatically superior to the others.

And the cool thing is, 2014 rules called for manufacturers to build gas/electric hybrids.

The cars of F1 are rigidly regulated in every aspect of their design down to the tiniest detail, from chassis to bodywork and on to the engine and gearbox. Teams are free to design and build their cars however they want, so long as they stick to the “formula.”

The engine formula was changed radically for the 2014 season. As well as requiring an electric hybrid design, it left the previous 2.4-liter V8 behind in favor of a tiny turbocharged 1.6-liter V6. Gone was the high-pitched noise of 18,000 rpm, in came the oddly low rumble of 12,000 rpm. Fans — and many drivers — hated it. Too quiet, they said. The engines buzzed instead of screaming like banshees.

F1 engines have actually been hybrids of a sort since 2009 when they added “KERS” — “kinetic energy recovery system” — to the design, which harvested braking energy, stored it in batteries, and gave some 82 hp back to the driver at the touch of a button. But only for 6.6 seconds per lap. The new engine essentially doubled that gift of power and made it available for much longer.

With some 160 electric horses added to the 600-plus already made by the little V6, today’s F1 cars easily hit speeds of around 200 mph, no slower than the V8s. Yet they use just over half as much fuel as last year. Remarkable by any standard.

One of the design challenges was that the fuel quantity allowed for a race was limited to 220 pounds, 35% less than in 2013. And the fuel-flow rate, which used to be unlimited, was also restricted, producing a top turbo boost pressure of about 50 psi.

The most interesting thing about these new engines is the hybrid side. There are now two points of waste-energy recovery by way of “motor generator units” or MGU. There’s the MGU-K, which recovers energy from braking, and the MGU-H that grabs energy from the exhaust via the turbo.

Specifically, the MGU-H takes power from the turbocharger’s spinning shaft, turning it into a generator and converting heat from the exhaust gases into power that’s either used immediately to propel the car or stored for future use. Essentially, it replaces a wastegate, which would dump excess exhaust.

The MGU-H also runs in reverse and thus controls and boosts the speed of the turbocharger, which compensates for turbo lag. There’s no waiting for the turbo to spool up. In essence, the turbo turns itself into a supercharger for a very brief moment until the exhaust power takes charge again.

And the coolest thing about this is that we’re bound to see it in cars and hopefully trucks before long, because it does what hybrids haven’t yet been able to do — recover waste energy while cruising. No longer dependent solely on braking as an additional power source, the hybrid package becomes far more useful.

And far more promising for us if turning the turbocharger into an electricity generator can be made to work for on-highway truck engines.

Rolf Lockwood is vice president, editorial, at Newcom Business Media, which publishes Today’s Trucking. He writes for HDT each month on the making, maintaining and using of trucks.

He can be reached at [email protected] or 416-315-1829.


  1. 1. Adam Burck [ January 16, 2015 @ 07:13AM ]

    The range of future technical innovations in heavy trucks is surely unlimited. The good news is we have a great truck hybrid system available now! The Autocar E3 takes our leading ACX truck and includes a hydraulic hybrid system that cuts fuel consumption 40% to 50% as well as substantially reduces other maintenance costs. Check out www.autocartruck/goinggreen


Comment On This Story

Comment: (Maximum 2000 characters)  
Leave this field empty:
* Please note that every comment is moderated.


We offer e-newsletters that deliver targeted news and information for the entire fleet industry.


ELDs and Telematics

sponsored by
sponsor logo

Scott Sutarik from Geotab will answer your questions and challenges

View All

Sleeper Cab Power

Steve Carlson from Xantrex will answer your questions and challenges

View All