Fleet Management

Truck Weight-Limit Hike Rejected by House

November 04, 2015

By David Cullen

SHARING TOOLS        | Print Subscribe
An amendment to the House highway bill that would have let states set a 91,000-pound weight limit on highway rigs fitted with a sixth axle, similar to this truck built for operation in Maine, was voted down on Nov. 3.
An amendment to the House highway bill that would have let states set a 91,000-pound weight limit on highway rigs fitted with a sixth axle, similar to this truck built for operation in Maine, was voted down on Nov. 3.

An amendment that would have liberalized truck-weight limits was rejected on Nov. 3 by a vote of 187-236 during floor consideration of the highway bill by the House of Representatives.

The measure would have allowed individual states to increase the federal vehicle weight limit to 91,000 pounds for tractor-trailers equipped with a sixth axle.

The amendment had been proposed by Rep. Reid Ribble (R-WI). It was based on the Safe, Flexible, and Efficient (SAFE) Trucking Act that he had introduced in September. The bipartisan amendment was co-sponsored by Reps. Collin Peterson (D-MN), David Rouzer (R-NC) and Kurt Schrader (D-OR).

According to Ribble, even though his amendment would have added up to 11,000 pounds to a truck’s GCW limit, the resulting vehicle would operate more safely because its mandated sixth axle would provide it with “stopping power equal to or better than that of a five-axle truck."

Ribble had noted when the SAFE Act was introduced that his proposal was written based on DOT safety and road wear data “to ensure that truck stopping times and pavement wear are as good or better than our current trucks.”

The Coalition for Transportation Productivity, which represents nearly 200 manufacturers, shippers, carriers and allied associations, blamed the amendment’s failure on intense lobbying by the railroad industry.

“The rail industry’s campaign to block truck productivity at any cost carried the day, as members of Congress were confronted with an astounding amount of misinformation about the SAFE Trucking Act,” CTP Executive Director John Runyan said in a Nov. 4 statement.

He added that the amendment’s defeat was “a loss for American manufacturers, which will continue to struggle to get goods to market efficiently, and for motorists, who would have benefitted from safer, less congested highways. CTP and our member organizations will continue looking for ways to safely improve truck productivity because the facts are on our side.”

The National Private Truck Council, a member of CTP, had separately stated its support of the SAFE Act early last month in a letter to the House Transportation and Infrastructure Committee. NPTC contended that Ribble’s measure would give states the “flexibility to safely confront highway capacity issues” by letting carriers run heavier, six-axle trucks on Interstate highways.

“H.R. 3488 would improve options for enhancing productivity,” wrote Gary Petty, president and CEO of NPTC. He stressed that the association “would not support this legislation if our members thought that it might diminish safety or harm highway or bridge infrastructure.”

However, Ribble’s SAFE Act never gained traction with other trucking industry associations. Back in September, the Truckload Carriers Association came out string against the proposal in a letter sent to Rep. Ribble. Recognizing that the bill “attempts to improve trucking productivity on our highways,” TCA stated in the letter that it opposes the measure because “it clearly would only benefit a minority of the industry.”

TCA argued that the cost to properly equip trailers and tractors to take advantage of the higher weight limit would not be compensated by rate increases, yet carriers would be compelled by customers to invest in the more costly equipment.

The association said it could cost “anywhere between $8,000 and $24,800, per tractor-trailer” to upgrade equipment to haul the additional 11,000 pounds that would become allowable if the bill had passed. What’s more, TCA noted, the extra weight of the third axle would actually reduce the additional weight allotment to between 8,000 and 8,500 pounds.

The Trucking Alliance, a coalition of trucking businesses that lobbies for safety improvements, also did not support Ribble’s bill. “This legislation wasn't written to benefit trucking companies, because it would drive up operating costs, drive down truck driver wages and curtail investments in safety technologies,” Lane Kidd, the Alliance’s Managing Director, told HDT.

And when asked by HDT if the American Trucking Associations had any reaction to the SAFE Act when it was introduced, ATA spokesperson Sean McNally had replied, “No, we don’t.” 

Comments

  1. 1. Bill Puckett [ November 04, 2015 @ 09:13AM ]

    I knew it would not pass. the real reason it was defeated is the money in overweight fines that the states collect unjustly i might add would have ceased
    That's the real reason it failed. it always about the benjamins when it comes to the goverment

  2. 2. 4b [ November 04, 2015 @ 10:50AM ]

    And the railroad squashing it like they did last time.. I would be all for it but the big question is where would the rate go for the added work? And the unreliable new junk trucks may not be fit for the task..

  3. 3. RBW [ November 04, 2015 @ 09:11PM ]

    I wonder how stress will effect truck and trailer parts after a couple years of 91000lbs. Also extra tire wear with all the scrubbing on corners. Not to mention turning damage to
    blacktop roads. Maybe one axle will be a lift axle like the dump trucks. Or the front or back could be steerable. Several possibilities.

  4. 4. Art Meyer [ November 05, 2015 @ 07:41AM ]

    I'm glad it didn't pass as this was all a cover up for the large trucking companies to increase revenue while at the same time not increasing driver pay. Find out who were the ones lobbying to have it pass and you will see.

  5. 5. Rich [ November 05, 2015 @ 09:49AM ]

    All 4 above comments hit it right on the head.
    The only people that would benefit are the "owned operators" driving for some of the cheap big companies...one more braking axel so when they use the jonny bar to save their own tractors brakes and wear the companies trailer brakes out.
    Not the safest thing to do but let the cheap company pay some of the bills.

  6. 6. Terrence Zignego [ November 07, 2015 @ 10:50AM ]

    Any one who thinks these heavier trucks are unsafe needs to know that they are already operating on state and county roads in some states already (like Wisconsin logging trucks at 98,000#) under special provisions from the states and not passing the law keeps them on side roads and off the Interstates, where any vehicle is safer. Weight per axle vs a 5 axle 80K truck is less, so they will stop faster and damage to roads wil not change much.

 

Comment On This Story

Name:  
Email:  
Comment: (Maximum 2000 characters)  
Leave this field empty:
* Please note that every comment is moderated.

Newsletter

We offer e-newsletters that deliver targeted news and information for the entire fleet industry.

GotQuestions?

ELDs and Telematics

sponsored by
sponsor logo

Scott Sutarik from Geotab will answer your questions and challenges

View All

Sleeper Cab Power

Steve Carlson from Xantrex will answer your questions and challenges

View All