Better fuel economy and lower emissions, already proven in extensive tests by Jacobs, have now been independently measured.  -  Photo: Jacobs Vehicle Systems

Better fuel economy and lower emissions, already proven in extensive tests by Jacobs, have now been independently measured.

Photo: Jacobs Vehicle Systems


Jacobs Vehicle Systems has completed testing to quantify the fuel savings and emissions benefits of Jacobs’ Cylinder Deactivation (CDA) technology. Test results showed that CDA reduced fuel consumption by 5% over the baseline in the Hot Federal Test Procedure cycle while increasing exhaust temperatures and limiting the cool-down of the selective catalytic reduction emissions system.

Testing was conducted by an internationally known third-party laboratory and funded by the Environmental Protection Agency on a 13L Navistar engine equipped with CDA.  The announcement was made in Atlanta during the Annual Meeting of the American Trucking Associations' Technology & Maintenance Council.

CDA reduces NOx output by creating higher exhaust temperatures in the operating cylinders for optimal SCR operation.

High temperatures necessary for optimal aftertreatment performance are maintained even when the engine is in low-load operation. With three cylinders of a six-cylinder engine deactivated, high exhaust gas temperatures can be maintained in the three operating cylinders. CDA also enables faster warm-up of the aftertreatment system after engine startup and minimizes cooling of aftertreatment substrate during coasting.

To demonstrate the capability of the CDA system, the proposed California Air Resources Board "Low Load" cycle was evaluated, and CDA was found to raise the exhaust temperatures by about 50 degrees C, reducing tail-pipe NOx emissions by 86%. Fuel consumption (and CO2) was reduced by 12%. SCR NOx conversion increased from 48% (baseline) to 95% (CDA).

Laboratory tests focused on the extent to which Jacobs’ CDA reduces NOx emissions during the low-load cycles representative of real-world driving conditions such as cold startups and frequent low-load and idle conditions that typically cause the most pollution due to a cool aftertreatment system. Testing also sought to quantify CO2 improvements at the same time.

CDA is already proven to increase fuel economy and reduce tailpipe emissions in heavy-duty diesel engines, but Jacobs said it welcomed the opportunity to have these benefits independently measured. More extensive tests and results will be published under a joint paper at the April 2020 SAE World Congress.

In November 2018, the EPA announced the need for additional nitrogen oxide (NOx) reductions in its Cleaner Trucks Initiative. This is especially important in areas of the U.S. with elevated levels of air pollution, a focus in California for the same reasons. Current heavy-duty truck rules for NOx, adopted in 2010, are expected to be replaced by new rules in the future.

Jacobs introduced CDA technology last year in a new application of proprietary components originally designed for the company’s High Power Density engine brake. HPD employs mechanisms in the valve train to disable the opening of the intake and exhaust valves. Jacobs is now involved in numerous CDA development and demonstration projects on commercial vehicle powertrains around the world.

About the author
Jim Park

Jim Park

Equipment Editor

A truck driver and owner-operator for 20 years before becoming a trucking journalist, Jim Park maintains his commercial driver’s license and brings a real-world perspective to Test Drives, as well as to features about equipment spec’ing and trends, maintenance and drivers. His On the Spot videos bring a new dimension to his trucking reporting. And he's the primary host of the HDT Talks Trucking videocast/podcast.

View Bio
0 Comments