September 9, 2013
The Interstate 5 Skagit River Bridge in Burlington, Wash., is on schedule to be completed later his week -- but there will still be detours through mid-November, according to the Washington State Transportation Department.
August 15, 2013
The permanent replacement for the collapsed Interstate 5 Skagit River Bridge span reached a major milestone this week as crews began setting eight enormous concrete girders that will support the new roadway.
July 25, 2013
Following the installation of a new permanent replacement span, contractor crews working for the Washington State Department of Transportation will begin upgrading and retrofitting the remaining sections of the Interstate 5 Skagit River Bridge.
July 16, 2013
Work to install the new permanent span for the Interstate 5 Skagit River Bridge in Burlington, Wash., is officially underway, but new delays and detours will happen again in a few weeks.
July 15, 2013
The California State Highway Patrol says all lanes along Interstate 5 have reopened in both directions at the state route 2 interchange following a truck crash and fire Saturday that shut them down.
June 13, 2013
The National Transportation Safety Board has issued its preliminary report into the May 23 bridge collapse along Interstate 5 in Washington, sending two vehicles into the Skagit River below.
June 6, 2013
If the trip along Interstate 5 in Washington state hasn’t been frustrating enough with a detour resulting the collapse of a bridge last month, it’s only going to get worse starting Friday evening.
June 5, 2013
The National Transportation Safety Board has released an update in its continuing investigation into the May 23 bridge collapse in Mount Vernon, Wash., along Interstate 5.
May 28, 2013
Washington Gov. Jay Inslee has announced a plan to replace the collapsed portion of the Interstate 5 bridge over the Skagit River near Mt. Vernon after it was damaged by a truck hauling an oversize load on Thursday, closing a section of the route.
May 23, 2013
UPDATED -- A bridge along Interstate 5 in Washington state partially collapsed Thursday evening, closing part of the route. Authorities are blaming it on a truck pulling an oversize load but the company says it has the proper permit to use the route.
We offer e-newsletters that deliver targeted news and information for the entire fleet industry.
The expert, Mark Betner from Citgo will answer your questions Ask a question
Carrier’s Exhaust Emissions System Gets CARB Conditional Approval
Aero Clad Bumper for Peterbilt 367 and 587
Zenith Electric Van Claims High Operating Savings
Con-way Freight Launches MyCon-way.com
Kenworth Makes Bendix Front Air Disc Brakes Standard on Class 8 Trucks
TireStat TPMS Sensors Go In or Out of Tires