What Exactly Constitutes an Underinflated Truck Tire?

July 2013, - WebXclusive

by Jim Park, Equipment Editor - Also by this author

SHARING TOOLS        | Print Subscribe
"Underinflated" isn't always this obvious. Enforcement officials are looking for a usable definition. (Photo by Evan Lockridge)
"Underinflated" isn't always this obvious. Enforcement officials are looking for a usable definition. (Photo by Evan Lockridge)

We've all heard the claims that running tires underinflated hurts fuel economy (1 to 1.5% for every 10% under, they say), increases tire wear and wrecks casings.

So what is underinflated?

By definition, it's any pressure less than the minimum recommended for the tire load. For example, a steer tire with a load of 6,000 pounds would be underinflated at 105 psi (see below). A drive tire loaded to 4,520 pounds would be underinflated at 75 psi. It all depends on the load on the tire and the minimum inflation pressure for the load. 


Why should we worry about defining underinflation? Because of the Federal Motor Carrier Safety Administration's CSA (Compliance, Safety, Accountability) enforcement program.

The Commercial Vehicle Safety Alliance is currently exploring how to define underinflation for enforcement purposes. CVSA has already settled on a definition of a "flat" tire: 50% of the max cold inflation pressure stamped on the sidewall of the tire, e.g., 60 psi in a tire stamped for its max load at 120 psi inflation pressure. That's clean and simple; now CVSA wants a similarly clean and simple definition of under-inflated.

That won't be as easy.

Peggy Fisher, president of Tire Stamp, led a discussion at this year's annual meeting of ATA's Technology and Maintenance Council on the subject and failed to resolve the question. Difficulty arises because of an almost outdated DOT requirement that evaluations of hot or in-service tires be temperature-compensated.

"DOT inspectors won't usually check tire pressure unless they suspect a problem, like the tire looks soft," Fisher said. "The problem is they have nothing to go by except what's stamped on the tire. To determine the proper inflation pressure of a tire, they need to know the temperature of the tire and the load on the tire. All that comes into play in determining the proper inflation pressure of a tire." 

Back in the days of tube tires, it was established that inspectors would subtract 15 psi from the gauged pressure of the tire to compensate for temperature. For example, a hot tire gauged at 85 psi would be considered cold-inflated to 70 psi. If that seems low, consider that according to the Goodyear's and Bridgestone's Load & Inflation tables, a 70-pound tire can still carry a load of 3,875 pounds. Michelin allows up to 4,500 pounds at 70 psi. Even at 3,875 pounds per tire, that would still allow 31,000 pounds over a tandem axle group. Is that tire actually underinflated with a light load?

There was also a CVSA official in the room at TMC. Kerri Wirachowsky of CVSA's vehicle committee, said the definition has to be simple or officers won't get it right.

"I don't think a lot of trucks get citations for underinflation, but they are getting written up on the inspection reports and that's just as impactful as far as CSA is concerned," she said. "As an officer checking tire pressure at roadside, I might not be at a scale; I don't know the load or the temperature of the tire. There's no way I can tell the variation between hot and cold. If you're going to make a reg change, get rid of the minus-15 and go to the lowest common denominator." 

TMC and CVSA are still working on this, and a solution doesn't seem close at this point. But maybe this information can help you in a DataQ challenge. Is that 70-psi tire really underinflated?


Load & Inflation Table examples

Michelin 275/80R22.5

Steer 5,980 @ 105 psi; 6,175 @ 110 psi

Drive/trailer 4,770 lb single @ 75 psi

Bridgestone 295/75R22.5

Steer 5980 @ 105 psi; 6175 @ 110 psi

Drive/trailer 4540 lb single @ 80 psi


Goodyear 295/75R22.5

Steer 5,980 @ 105 psi; 6175@110

Drive 4,690 @ 75 psi

Read more about tire inflation in the July issue of HDT.


  1. 1. Jamie Serfass [ July 10, 2013 @ 11:52AM ]

    Actually the load inflation tables are labeled for single and dual configuration not steer or drive/trailer.

    Considering 34K for a set of tandems divide by 8 tires and the max legal load most tires will see is 4,250 lbs each. You can run 11R24.5 tires at 70 psi and be properly inflated for the max load in a dual application.
    Dual apps are actually rated with higher psi than single to account for one of the pair running on an elevated section compared to the other such as an edge of a roadway where one would bear more weight than the other.

    Most tires are running over-inflated. Some are over-inflated so there is 'extra' in case some leaks out. Some are over inflated because of that number on tyhe sidewall. Some are over-inflated for better mpg. Running rock-hard tires is bad for the tire, truck, driver comfort and highway. A properly inflated tire is the first part of a suspension system as it absorbs all of the initial road bumps.


Comment On This Story

Comment: (Maximum 2000 characters)  
Leave this field empty:
* Please note that every comment is moderated.


We offer e-newsletters that deliver targeted news and information for the entire fleet industry.



The expert, Mark Betner from CITGO, will answer your questions

View All



The expert, Rence Oliphant from Hendrickson, will answer your questions

View All