Why Should You Retread Your Tires?

May 2013, - WebXclusive

by Jim Park, Equipment Editor - Also by this author

SHARING TOOLS        | Print Subscribe

Trade it Now, or Trade it Later

Retread plants grind off tread rubber so the new tread will fit properly around the casing. All the rubber removed in that process is lost miles-per-thirty-second to the fleet. Bridgestone suggests tires be run down to about 6/32 before retreading in order to get maximum safe mileage from the tread.
Retread plants grind off tread rubber so the new tread will fit properly around the casing. All the rubber removed in that process is lost miles-per-thirty-second to the fleet. Bridgestone suggests tires be run down to about 6/32 before retreading in order to get maximum safe mileage from the tread.

Time for a bit of simple math. If you were to take a $400 tire out of service and sell the casing to a retreader for $100, the net cost of the tire is $300,  using round numbers. If the casing is retread twice, or perhaps three time, the net cost of the original tire can be reduced to as little as $100.

Now compare the cost of two retreads versus two new tires, even at a trailer position, and you'll see how you're saving money twice each time a tire is retreaded.

We assume here that you're treating your tires well, repairing them properly, and not abusing the casing. Depending on your location and a few other factor, like the market for retreadable casings, you might get $100 for a casing in tip-top shape -- an A-grade casing. If you beat the thing up, it could be only a B- or a C-grade casing. Here again, if you're maintenance program isn't up to par, you're throwing money away in casing value. 

"Currently, in most of the U.S., 22.5 low-profile casings (295/75R22.5 and 275/80R22.5) are in very short supply," says Bowman. "They'll fetch the highest casing value, but you may get $95 per casing in one part of the country and only $65 in another, depending on the local market."

Casing Killers

The number 1 killer of tire casings is heat, and that's directly attributable to underinflation.    

Each revolution of the tire causes the steel wire in the casing to flex. A tire will go around about 500 times per mile, times 100,000-plus miles a year for a couple of years. Try flexing a paperclip like that and see how long it lasts.

"It's critical that proper pressure and loading be maintained so the casing will function as designed through the millions of flexing cycles a tire undergoes in its service life," says Bridgestone's director of engineering for commercial products and technologies, Guy Walenga. "That keeps the casing strong and makes it a good candidate for retreading."

Improper repairs and rusted belts are the next most likely killers of casing value. Each is manageable. Eliminating them will preserve casing value. Tire repairs aren't a problem for retreaders, even section repairs, provided they are done to accepted industry standards, but improper repairs will render the casing non-retreadable.

"There could be any number of nail hole repairs, so long as the repair units do not overlap, which would be considered an improper repair,” says Kevin Rohlwing, senior vice president of training for the Tire Industry Association. "Rust in the tires' steel cords is bad news for retreading. Punctures should be repaired as soon as possible after detecting the wound to prevent moisture from wicking its way into the belts and ruining the casing."

Retreads Keep You Honest

While that may sound like a silly statement, consider the tire maintenance program as whole. If you treat tires as disposable commodities, then retreading probably isn't for you – though it should be. If you invest heavily in tire management and maintenance, a retread program could very beneficial.

Several of the major tire makers offer cost-effective, cradle-to-grave tire management programs that can provide the labor and the oversight needed to make such programs successful. Depending on the need and the volume, they can provide regular yard surveys, pressure checks, reports and recommendations, mounting and dismounting service as well as on-road repairs, casing management through dealer networks, and monthly billing.

Each time you turn a casing into a retreaded tire, you extend its life and lower its life cycle cost. You also get a good-as-new tire for half to two-thirds the cost of a new one, and that's harder to ignore than your tire pressure.

« Previous  |  1  2  |  Next »


  1. 1. gary reif [ May 15, 2013 @ 03:46AM ]

    The story reads should last a million miles , but they don't. Save your money and costly downtime and purchase only virgin rubber. The only good thing a worn out tire is good for is starting a brush fire.

  2. 2. Shelley Hughes [ May 20, 2013 @ 11:34AM ]

    Disagree with ya Gary Reif! My husband and I have had GREAT luck with recaps from a place in Kansas City called Mid States Tire and Retread. I think it all depends on where you are getting your work done. We've been in the trucking business for more than 30 years, and yes , we've ran into retread shops that were not worth it, but I have to say we've been with Kevin at Midwest for several years now and have had tremendous luck with his work. He is very particular about the age and quality of casings and has machinery to do close inspections. We've gotten great mileage out of them and proper wear!

  3. 3. Johan Gouws [ September 20, 2013 @ 12:33AM ]

    Did you know that even a new tire get its tread cap after the casing is build? to not retread is money down the drain

  4. 4. Mickalina LaRoche [ October 01, 2014 @ 05:57AM ]

    I have low profile tires that need retreding what do I do how do I go about it

  5. 5. Jason L [ August 05, 2015 @ 03:34PM ]

    @MIckalina LaRoche You should find a well established retread shop. Don't shop simply on price. All the major tire brands have an associated retread system, however they can all retread all casing brands. The better the original casing brand the better results you will get on retreading. Unfortunately Gary, commented above, and is kinda clueless. Yes in todays market you can buy a cheap truck tire for only maybe $50 more than having your tire retreaded but the premium retread will run circles around a cheap chinese new tire insofar as mileage as concerned. What Gary and folks like him do not understand is, a tire is simply a container meant to hold air at very precise pressures for the load carried. ALL tires will fail if under inflated or even over inflated. If your money is important to you, check air pressures frequently and consult a psi chart for your tires and load.


Comment On This Story

Comment: (Maximum 2000 characters)  
Leave this field empty:
* Please note that every comment is moderated.


We offer e-newsletters that deliver targeted news and information for the entire fleet industry.


ELDs and Telematics

sponsored by
sponsor logo

Scott Sutarik from Geotab will answer your questions and challenges

View All

Sleeper Cab Power

Steve Carlson from Xantrex will answer your questions and challenges

View All