Maintenance

Preventing Flat Tires

Eighty percent of blowouts could be prevented if tires were kept properly inflated

March 2013, TruckingInfo.com - Feature

by Jim Park, Equipment Editor - Also by this author

SHARING TOOLS        | Print Subscribe
Once the tread comes off, a blowout won't be far behind. You're down, with a $1,000 repair bill to show for it.
Once the tread comes off, a blowout won't be far behind. You're down, with a $1,000 repair bill to show for it.
A driver picks up a trailer from a drop yard. Before departing, the driver does a walk-around inspection, kicks the tires, checks the lights and then sticks it into the wind. He or she has no idea how much air pressure is in those tires, except to be fairly sure none of them is flat — visibly flat, that is. Any one or several of those tires could be underinflated, or even technically flat.
An hour or two down the road after loading, ka-blooey! Chunks of hot rubber are flying everywhere and the driver faces a couple of hours of downtime. The fleet could be looking at a repair bill close to $1,000.

All that over a few measly pounds of air pressure.

Flat tires are more than a little annoying, but blowouts are expensive, mission-critical failures that cost a great deal of money. The trick is to prevent the former from causing the latter.

“You don't go from properly inflated to a blowout instantaneously unless you hit something on the highway,” says Curtis Decker, manager of product development at Continental Tire. “We estimate that about 80% of the roadside tire failures are a direct result of creeping air loss.”

ADVERTISEMENT

In other words, 80% of blowouts could be prevented if tires were kept properly inflated.

There is a well-founded expectation that tires will lose 2% of their inflation pressure, by volume, over about 30 days, even when the casing, the valve stem and the tire bead/ rim flange contact area are in perfect condition. The problem with that line of thinking is that people are inclined to say, I guess I only need to check my tires about once a month. Wrong.

Decker says it's uncommon to find a perfectly sealed tire/wheel assembly, so the actual rate of seepage could be as high as 2% per week, or 2% per day if there are other irregularities, such as puncture wounds from nails, a contaminated rim flange or bad valve stem.

“If you build your tire maintenance practices around what you're told is normal air loss, you're going to get caught on the back side of the curve,” he says. “At best, you'll see irregular wear related to inflation, poorer fuel mileage, etc. At worst, the tire will blow out because it has been run flat and damaged by excessive sidewall flex and deterioration of the rubber compounds.”

Painless tire maintenance

There's a rather strange conundrum in trucking: Everybody knows about the costs and risks of running underinflated tires, and almost everybody is aware of the many proactive measures they could take to prevent or monitor inflation loss, yet uptake on such products remains low.

We have tire pressure monitoring systems that offer everything from basic indications of low tire pressure all the way up to systems that build tire profiles and populate databases with information about the life of the tire on an almost hour-by-hour basis. There are also inflation systems that top up tire pressure automatically and invisibly, and there are technologies that automatically seal tires in the event of a puncture.

Keeping air in your tires is much less of a chore than it once was, but it comes at a cost. Decker says the challenge has been getting drivers and fleets to see the value of the upfront investment in such technology rather than experience the pain of a roadside tire failure.

“It's the human propensity to be reactive rather than proactive, and that even goes for cost justification,” Decker says. “Drivers will weigh the cost in time of manually checking pressure of up to 18 tires versus the risk of postponing that chore as long as possible. On the other hand, the fleet or driver could make an upfront investment in technology to do that job for them. It then becomes a case of watching the money you'd pay for such a system physically leaving your wallet, versus the expectation that you'll get away with not checking tire pressure just one more time.”

Eighty percent of blowouts could be prevented if tires were kept properly inflated.
Eighty percent of blowouts could be prevented if tires were kept properly inflated.

Of course, air doesn't just leave a tire on its own. Punctures are inevitable, but Goodyear's DuraSeal can take care of that for you as well. DuraSeal is a layer of gel-like rubber material that is built into the tire casing between the liner and the body ply that will automatically seal holes up to 1/4-inch in diameter.

Donn Kramer, Goodyear's director of marketing for commercial tires, says DuraSeal is integrated into the tread face section of the tire casing, and it won't affect retreading potential or leak out of the tire.

“The long-term value of DuraSeal is that it extends casing life by preventing casing damage,” he says. “Short term, it prevents flat tires due to punctures. Taken together, it will keep tires inflated under conditions where a flat would normally sideline a truck, and because it prevents run-flat situations, it prevents casing damage.”

There are also a number of after-market tire sealants that have proven effective, but they have to be removed from the tire before servicing and can be pretty messy.

With three technologies to choose from — tire pressure monitoring to warn fleets and drivers of a pressure loss, automatic inflation systems that keep tires inflated to a preset pressure, and sealants that prevent air loss due to punctures — there's more than one way to tackle the inflation challenge. The fourth, of course, is regular tire pressure checks and inflation top-ups.

Each option comes at a cost, but each offers a measurable return on investment. Kramer says the best way to prove the ROI is to have a good tire management system to begin with to track costs and failure causes.

“Once you know what's happening to your tires and how much it costs you, it's easier to choose a technology to tackle your problem,” he says.

That's especially true with wide-base single tires. If one of those goes down, the truck is down, and if it blows out, the wheel is at risk as well.

It's astonishing that such an easy solution with quantifiable returns exists to help prevent 80% of the blown-out tires, yet every day more fleets scatter their profits all over the highways of the nation.

Next Page: Flat tires and inflation; How flat is flat?

Comment On This Story

Name:  
Email:  
Comment: (Maximum 2000 characters)  
Leave this field empty:
* Please note that every comment is moderated.

Newsletter

We offer e-newsletters that deliver targeted news and information for the entire fleet industry.



GotQuestions?

LUBRICANTS

The expert, Mark Betner from Citgo will answer your questions
Ask a question

Sponsored by

Magazine